Ruixin Energy Equipmnet
Innovation Excellence
Add to Cart
I. Introduction
GU Connector is used in connection with GS pulling tool, and they form GR Pulling Tool.
II.Technical parameters of common specifications
| Szie | Actual OD | FN | Fishing OD | Connection | Lower connection thread |
| 2″ | 1.81″ | 1.375″ | 1.38″ | 15/16″-10UN | 1/2-13UN″ |
| 2.5″ | 2.25″ | 1.375″ | 1.81″ | 15/16″-10UN | 5/8-11UN″ |
| 3″ | 2.72″ | 1.75″ | 2.31″ | 1-1/16″-10UN | 5/8-11UN″ |
| 3.5″ | 3.11″ | 2.313″ | 2.62″ | 1-1/16″-10UN | 5/8-11UN″ |
Technical parameters can also be according to user requirements
III. Structural characteristics:
GR pulling tool is mainly composed of GS pulling tool (1) and GU Shear Up Adaptor (2), as shown in the attached assembly drawing.
IV..Maintenance
1. After the tool is disassembled, check the damage of each component and replace the damaged parts.
2. When assembling, apply a thin layer of grease on the thread surface.
3. After assembly, the fishing neck is attached with thread protector and marked for later use.
Welcome to contact us at any time.
