Ruixin Energy Equipmnet
Innovation Excellence
Add to Cart
Custom Slickline Wireline Running Tool X Running Tool
I. Overview:
The X-type running tool is a special tool for putting X/XN-type lock cores. It can selectively put the fluid control device with X/XN-type lock cores into the X/XN-type seating joints in the well.
II.Technical parameters of common specifications:
| Nominal Size | Actual OD | Fishing Neck | Top Connection |
Bottom Connection
| |
| 1.5″ | 1.41″ | 1.188″ | 15/16″-10UN |
3/8-16UN″
| |
| 1.625″ | 1.593″ | 1.188″ | 15/16″-10UN |
3/8-16UN″
| |
| 1.875″ | 1.75″ | 1.375″ | 15/16″-10UN |
1/2-13UN″
| |
| 2.313″ | 2.175″ | 1.75″ | 15/16″-10UN | 5/8-11UN″ | |
| 2.75″ | 2.718″ | 2.313″ | 1-1/16″-10UN | 2/4-10UN | |
| 2.813″ | 2.72″ | 2.313″ | 1-1/16″-10UN | 3/4-10UN | |
| 2.875″ | 2.938″ | 2.313″ | 1-1/16″-10UN | 3/4-10UN | |
| 3.313″ | 3.406″ | 2.313″ | 1-1/16″-10UN | 1-3/8-12UN | |
| 3.813″ | 3.890″ | 2.313″ | 1-1/16″-10UN | 2-1/8-12UN | |
III.maintenance:
1. After the tool is disassembled, check the damage of each part and replace the damaged parts.
2. When assembling, a thin layer of grease should be applied to the thread surface.
3. After assembling, put the protective wire on the thread of the salvage neck connection and mark it for later use.
Welcome to contact us at any time.
